Command Descriptions
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-91
Might return 214 as the first waveform data point that will be
transferred.
CURVe?
DATa:STOP
Sets or queries the last data point in the waveform that will be
transferred when executing the CURVe? command. This lets you
transfer partial waveforms from the oscilloscope.
When using the CURVe command, the oscilloscope stops reading
data when there is no more data to re ad or when the 2500 data point
limit is reached.
Waveform
DATa:STOP <NR1>
DATa:STOP?
<NR1> is an integer value that ra nges from 1 to 2500, and speci fies
the last data point that will be transferred. When DATa:STOP is less
than DATa:STARt, the values are swapped internall y for CURVe?.
If you always want to transfer complete waveforms, set DATa:STARt
to 1 and DATa:STOP to 2500.
DATa:STOP 150
Specifies that the waveform tra nsfer will stop at data point 150.
DATa:STOP?
Might return 285 as the last data point that will be transferred.
Related Commands
Group
Syntax
Arguments
Examples
To Next Page
Loading...
