Command Descriptions
2- 102
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
DISplay:STYle VEC
Sets the display to connect adjacent data points.
DISplay:STYle?
Might return DOTS indica ting that the display shows individual
waveform data points.
ERRLOG:FIRST? (Query Only)
Returns the first entry in the error log, or an empty string i f the error
log is empty. Use this command along with ERRLOG:NEXT? to
retrieve error log messages.
Calibration and Diagnostic
ERRLOG:FIRST?
Refer to the service ma nual for your oscilloscope for information
about error log message format.
ERRLOG:NEXT? (Query Only)
Returns the next entry in the error l og, or an empty string if t he e rror
log is empty or you have reached the end of the log. To start at the
top of the error log, run the ERRLOG:FIRST? query to return the
first error log message. Then use the ERRLOG:NEXT? query to step
through the error log.
Calibration and Diagnostic
ERRLOG:NEXT?
Examples
Group
Syntax
Returns
Group
Syntax
To Next Page
Loading...
