Command Descriptions
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2- 259
execution error with event code 2244 (waveform requested is not
active).
NOTE. For the TDS210 or TDS220 oscilloscope (firmware below
V 2.00) with a TDS2CMA communications module, the set form is
ignored. The query always returns zero.
Waveform
WFMPre:YZEro <NR3>
WFMPre:YZEro?
<NR3> is a value, expressed in YUNits.
WFMPre, Additional Commands for Compatibility
The set form of the se additional commands is ignored. The query
form generates event messages 100 (Command Error) and 420
(Query Unterminated). These commands are included for compati-
bility purposes only.
Table 2--31 lists additional WFMPre commands.
Table 2- 31: Additional WFMPre commands
Command Argument Description
WFMPre:XMUlt <NR3> Horizontal (X-axis) scale factor
WFMPre:XOFf <NR3> Horizontal (X-axis) offset
WFMPre:ZMUlt <NR3> Z-axis scale factor
WFMPre:ZOFf <NR3> Z-axis offset
Group
Syntax
Arguments
To Next Page
Loading...
Need help?
General
