Tektronix TDS210 - Page 282

Command Descriptions
2- 262
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
Otherwise, the set form of this command is ignored.
WFMPre:<wfm>:WFId? (Query Only)
Same as WFMPre:WFId?, except that <wfm> specifies the source
waveform instead of DATa:SOUrce.
WFMPre:<wfm>:XINcr
Same as WFMPre:XINcr, except that <wfm> specifies the
source/destination waveform instead of DATa:SOUrce and
DATa:DESTINATION.
For set commands, if <wfm> is not a reference waveform, the
oscilloscope generates error 2241.
WFMPre:<wfm>:XUNit
Same as WFMPre:XUNit, except that <wfm> specifies the
source/destination waveform instead of DATa:SOUrce and
DATa:DESTINATION.
WFMPre:<wfm>:XZEro
Same as WFMPre:XZEro, except that <wfm> specifies the
source/destination waveform instead of DATa:SOUrce and
DATa:DESTINATION.
For set commands, if <wfm> is not a reference waveform, the
oscilloscope generates error 2241.
WFMPre:<wfm>:YMUlt
Same as WFMPre:YMUlt, except that <wfm> specifies the
source/destination waveform instead of DATa:SOUrce and
DATa:DESTINATION.