Command Groups
2-30
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
Table 2- 20: Power Measurement commands (TPS2000 with TPS2PWR1
only) (Cont.)
Header Description
SWLoss:AVErage:N? Return the number of measurements used to
calculate the averaged value for switching loss
commands
SWLoss:AVErage:TOTAL? Return the sum of the turn-on, turn-off, and
conduction switching losses for an Average
measurement
SWLoss:AVErage:TURNOFF? Return the power loss of the device under test when
the device is transitioning from on to off
SWLoss:AVErage:TURNON? Return the power loss of the device under test when
the device is transitioning from off to on
SWLoss:ENABLe Set or query switching loss measurements on or off
SWLoss:LEVELS Return oscilloscope Switching Loss Measurement
settings to factory default (SWLoss:TONSTART,
SWLoss:TONEND, SWLoss:TOFFSTART,
SWLoss:TOFFEND only)
SWLoss:LOG:CONDUCTION? Return the Conduction Loss for a switching loss
measurement
SWLoss:LOG:INDEX Set or query which measurement to return for a
SWLoss:LOG command
SWLoss:LOG:TOTAL? Return the Total Loss for a switching loss measure-
ment
SWLoss:LOG:TURNOFF? Return the Turn-Off Loss for a switching loss
measurement
SWLoss:LOG:TURNON? Return the Turn-On Loss for a switching loss
measurement
SWLoss:SAVE Saves the Switching Loss Measurements
SWLoss:SOURCES Set or query the input sources for Switching Loss
Measurements
SWLoss:STOPAfter Set or query the number of acquisitions used for
Switching Loss Measurements
To Next Page
Loading...
Need help?
General
