Field Description
• ' ", !"
: The device sends no IE (Information Element) for channel
identification. The exchange selects the channel to be used.
• *3 )! ",
: The device selects the channel to be used and signals this to
the exchange.
You can normally use the default value. It is only necessary to
change the setting in a few special cases.
If you encounter problems with outgoing calls, ask your provider
whether a special value has to be set.
Clock Mode Only if Port Usage = ="7  ="7 ,3)
Defines which connection partner sends the clock signal for
synchronization between the sender and the recipient. If the
clock signal is not sent by the exchange itself, one of the con-
nection partners must sent the signal.
Possible values:
• <: The device receives the clock signal.
• ,: The device sends the clock signal.
ISDN Switch Type
Only if Port Usage = /# /Select the ISDN connection
type.
Possible values:
• /# / 23# ( *,#: Up to 31 PPP in-
terfaces can be configured for leased lines to different destin-
ations.
• /# /E  ?&)", +$ ; +:
1984 kbps, structured
• /# / 0#3"3 +$: 2048 kbps, unstruc-
tured
Custom Time Slots
Only if Port Usage = /# / and ISDN Switch Type =
/# / 23# ( *,#.
You have the option to bundle any channels on the physical lay-
11 Physical Interfaces Teldat GmbH
132 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
