Field Description
up over several interfaces ( %3,,7). If you choose %3,
,7, you can connect several DSL connections from a pro-
vider over PPP as a static bundle in order to obtain more band-
width. Each of these DSL connections should use a separate
Ethernet connection for this. At the moment, many providers are
still in the process of preparing the PPPoE Multilink function.
For PPPoE Multilink, we recommend using your device's Ether-
net switch in Split-Port mode and to use a separate Ethernet in-
terface e.g. , for each PPPoE connection.
If you also want to use an external modem for PPPoE Multilink,
you must run your device's Ethernet switch in Split-Port mode.
PPPoE Ethernet Inter-
face
Only for PPPoE Mode = *
Select the Ethernet interface specified for a standard PPPoE
connection.
If you want to use an external DSL modem, select the Ethernet
port to which the modem is connected.
When using the internal DSL modem, select here the EthoA in-
terface configured in Physical
Interfaces->ATM->Profiles->New.
PPPoE Interfaces for
Multilink
Only for PPPoE Mode = %3,,7
Select the interfaces you want to use for your Internet connec-
tion. Click the Add button to create new entries.
User Name Enter the user name.
Password Enter the password.
VLAN Certain Internet service providers require a VLAN-ID. Activate
this function to be able to enter a value under VLAN ID.
VLAN ID
Only if VLAN is enabled.
Enter the VLAN-ID that you received from your provider.
Always on Select whether the interface should always be activated.
The function is enabled with ,.
Teldat GmbH
17 WAN
bintec Rxxx2/RTxxx2 273
To Next Page
Loading...
Need help?
General
