Field Description
defined as the default route.
The function is enabled with ,.
The function is enabled by default.
Create NAT Policy Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is enabled with ,.
The function is enabled by default.
Local IP Address Only for IP Address Mode = *"
Assign an IP address from your LAN to the PPT interface, which
is to be used as your device's internal source address.
Route Entries Only if IP Address Mode = *"
Define other routing entries for this PPTP partner.
Add new entries with Add.
• @ -##: IP address of the destination host or
network.
• '#7: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
• %": The lower the value, the higher the priority of the
route (range of values ... ). The default value is .
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field Description
Block after connection
failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed. The de-
fault value is .
Maximum Number of
Dialup Retries
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are to .
17 WAN Teldat GmbH
280 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
