Field Description
Possible values:
• 0) (default value): The peer is available for setting up a tunnel
immediately after saving the configuration.
• .1: The peer is initially not available after the configuration
has been saved.
Description Enter a description of the peer that identifies it.
The maximum length of the entry is 255 characters.
Peer Address Enter the official IP address of the peer or its resolvable host
name.
The entry can be omitted in certain configurations, whereby
your device then cannot initiate an IPSec connection.
Peer ID Select the ID type and enter the peer ID.
This entry is not necessary in certain configurations.
The maximum length of the entry is 255 characters.
Possible ID types:
• 93,,& D3,! . ' 9D.'
• , -##
• 6 -##
• -*'.' .# 3# '
• >& .: Any string
On the peer device, this ID corresponds to the Local ID Value.
Internet Key Exchange Not available to devices in the WIxxxxn series. These devices
only support IKEv1.
Select the version of the Internet Exchange Protocol to be used.
Possible values:
• > (default value): Internet Key Exchange Protocol Ver-
sion 1
• >: Internet Kex Exchange Protocol Version 2
18 VPN Teldat GmbH
328 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
