Fields in the IP Mode and Routes menu.
Field Description
IP Address Mode Select whether your device is to be assigned a static IP address
or whether it should be assigned this dynamically.
Possible values:
• *" (default value): You enter a static IP address.
• -##: Only for PPTP Mode = '*: Your
device dynamically assigns an IP address to the remote ter-
minal.
• -##: Only for PPTP Mode = 81# 2,
%: Your device is dynamically assigned an IP ad-
dress.
Default Route Only if IP Address Mode = *"
Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with ,.
The function is disabled by default.
Create NAT Policy
Only if IP Address Mode = *"
When you configure an PPTP connection, specify whether Net-
work Address Translation (NAT) is to be enabled.
The function is enabled with ,.
The function is disabled by default.
Local IP Address Only for IP Address Mode = *"
Assign the IP address from your LAN to the PPTP interface
which is to be used as your device's internal source address.
Route Entries
Only if IP Address Mode = *"
Define routing entries for this connection partner.
• @ -##: IP address of the destination host or
LAN.
• '#7: Netmask for Remote IP Address
18 VPN Teldat GmbH
374 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
