iTRANS 2
FIXED POINT SINGLE OR DUAL GAS MONITOR
WITH DUAL ANALOG OUTPUTS
USER MANUAL
Revision 7.0
5.6.8 Set System Time – Day
The system’s day of the month setting is designated with a “d”
in the status bit and current value next to it. To change the
day, press the “↵” button during the 10-second countdown.
If you do not press “↵” during the 10-second countdown, the
will return to the Normal Operating Mode. If you
initiate the days option, the status bit will start to flash and the
day can be changed by using the “↑” and “↓” keys.
When the desired value is reached, press the “↵” key. If the
value is not saved before the time-out, the will go
back to the Programming Mode.
Figure 5-21 Setting System Day
5.6.9 Set System Time – Month
The system’s month setting is designated with an “E” in the
status bit and current value next to it. To change the month,
press the “↵” button during the 10-second countdown. If
you do not press “↵” during the 10-second countdown, the
will return to the Normal Operating Mode.
If you initiate the month option, the status bit will start to flash
and the month value can be changed by using the
“↑” and “↓” keys. When the desired value is reached, press
the “↵” key. If the value is not saved before the time-out, the
will go back to the Programming Mode.
Figure 5-22 Setting System Month
5.6.10 Set System Time – Year
The system’s month setting is designated with an “8” in the
status bit and current value next to it. To change the year,
press the “↵” button during the 10-second countdown. If you
do not press “↵” during the 10-
will return to the Normal Operating Mode
If you initiate the month option, the status bit will start to flash
and the month value can be changed by using the
“↑” and “↓” keys. When the desired value is reached, press
the “↵” key. If the value is not saved before the time-out, the
will go back to the Programming Mode.
Figure 5-23 Setting System Year
To Next Page
Loading...
