iTRANS 2
FIXED POINT SINGLE OR DUAL GAS MONITOR
WITH DUAL ANALOG OUTPUTS
USER MANUAL
Revision 7.0
5.6.18 Last calibration – Month
The month of last calibration is designated with an “7” in the
status bit. The mouth of last calibration is displayed on the top
line of the LED display. This information can’t be editable.
Figure 5-31 Month of last
calibration Display
5.6.19 Last calibration– Year
The year of last calibration is designated with an “9” in the
status bit. The year of last calibration is displayed on the top
line of the LED display. This information can’t be editable.
Figure 5-31 Year of last
calibration Display
5.6.20 Reset
To activate the reset, set, press the “
” button during the 10-
second countdown. If you do not press “↵” during the 10-
second countdown, the
will return to the Normal
Operating Mode
Figure 5-31 Reset Display
To Next Page
Loading...
