4.4 Getting Started
Connect the appropriate cables to the transmit and receive IF and/or L-band connectors at
the rear of the unit, along with the cable(s) for the traffic interface.
Power the unit and wait for it to complete its initialization when it will display summary
status information.
From the front-panel menu, select Main->Edit->All in order to set the configuration prior to
operation.
It is also possible to set up the unit from a web browser as described in Section 7.4.
When setting up a number of units that have similar configurations, the configuration
settings of one unit can be saved, extracted and then transferred to each of the other
units in turn. This procedure is explained in Section 7.4.3.
Getting started is covered in more detail in the Q-Flex™ modem Quick Start Guide
(provided with the unit).
To Next Page
Loading...