Modem IP
Gateway
Default:
0.0.0.0
Description: Sets the IP address of a default gateway. The gateway represents the
‘next hop’ destination, which is normally the address of a router, for
packets destined for somewhere other than the local network. This is
used whenever the IP mode is set to Routing. An address of 0.0.0.0
means that the gateway is not set.
Table 6-55 M&C IP Address, Subnet Mask & Modem IP Gateway
6.2.2.10 Traffic/Satelite IP Addresses and Subnet Masks
Traffic
IP address
This sets the IP address for the modem’s IP Traffic port. (DHCP is not
supported for this address and therefore an address must be manually
entered.)
When IPv6 support is selected on the menus then additional address
entry options are provided.
Traffic
IP subnet
mask
This sets the subnet mask for the modem’s IP Traffic port.
Satellite
IP address
This sets the IP address for the modem’s satellite IP port. This is only
used when in routing mode, when the modem acts as a two-port router.
Satellite
IP subnet
mask
This sets the subnet mask for the modem’s satellite IP port.
Table 6-56 Traffic/Satellite IP Address & Subnet Mask
To Next Page
Loading...