Telesis PINSTAMP TMP4100 Series - TMP4150 and TMP4155 Marking Heads

TMP4100-Series Installation/Maintenance
33480D01.DOC 1-3
1.2.3 TMP4150 and TMP4155 Marking Heads
Weight
1
.......................................8.7 lb. (3.9 kg) marking head, brackets, and cable
Dimensions (
L x W x H)
2
..............9.89 x 5.12 x 4.96 in. (251 x 130 x 126 mm) with 25XL pin (w/o boot*)
10.14 x 5.12 x 4.96 in. (258 x 130 x 126 mm) with 150S pin (w/o boot*)
Boot Material...............................
TMP4150: Neoprene
TMP4155: Nitrile (synthetic rubber)
* Boot Dimension...........................5.33 in. (135 mm) diameter
X-axis Travel...............................2.0 in. (50 mm) maximum
Y-axis Travel...............................0.3 in. (7.6 mm) maximum
Number of Impact Pins................1
Pin Type ......................................25XL- or 150S-series
Pin Material.................................Powered Metal or Carbide (25XL-series)
Powered Metal or Carbide-tipped (150S-series)
Pin Stroke: 25XL-series pin........0.125 in. (3.1 mm) recommended; 0.5 in. (12.7 mm) maximum
150S-series pin.........0.125 in. (3.1 mm) recommended; 0.25 in. (6.35 mm) maximum
Air Consumption
3
At Idle ..............................0.04 SCFM maximum
While Marking.................0.80 SCFM maximum
Operating Temperature................32° to 122°F (0° to 50°C)
Humidity......................................0% to 80%
NEMA Rating..............................12 (I.P. 55)
Notes:
1) Weight listed includes 25XL carbide pin and pin cartridge; weight does not include any support tooling.
2) Dimensions without marker cable or air line.
Length may slightly exceed dimension listed due to bend radius of marker cable and air line (if applicable).
3) Air consumption is dependent on the type of pin being used.