TMP4100-Series Installation/Maintenance
33480D01.DOC 1-5
1.3 UNPACKING THE EQUIPMENT
This section provides guidelines for receiving and unpacking the TMP4100-Series marking equipment.
CAUTION
If your equipment arrives during cold weather, allow the components to
warm up for several hours before opening the containers. Exposing the
equipment to room temperatures may cause condensation in the units.
When your marking equipment arrives, check the shipping cartons for damaged corners, holes through the
cardboard, or any other signs of damage. Ask the delivery service to note any damage to the containers on the
delivery receipt. Save all packing materials in case you need to return any components.
1.3.1 Accounting For Equipment
Check the materials against the packing list. Note any discrepancies to your delivery service and request that
they note the discrepancies on the delivery receipt. The marking equipment consists of:
•
TMP4100, TMP4100E: Marking head with pre-attached pistol-grip handle
•
TMP4150, TMP4155: Marking head with mounting plate.
• Marker cable (pre-wired to head)
•
TMP4100, TMP4150, TMP4155: Filter/regulator unit
•
TMP4100, TMP4150, TMP4155: Air line(s)
Additional components may be included with the marking equipment. Specific information for optional
equipment may be provided in a separate installation manual. Specific information for custom equipment
may be provided in a custom addendum.
To Next Page
Loading...
