TMP4100-Series Installation/Maintenance
33480D01.DOC 2-1
Section 2
Maintenance
2.1 OVERVIEW
This section provides troubleshooting, testing, repair, and replacement procedures for the marking head. Any
additional troubleshooting, fault isolation, servicing, maintenance, or repair of TMP4100-Series marking head
that is not explicitly contained in this document must be performed by repair agencies authorized by Telesis
Technologies, Inc.
2.2 MAINTENANCE PRECAUTIONS
1. Turn all power OFF when performing maintenance on the marker.
2. Ensure that all equipment energy sources are turned off or disconnected and that the switches/valves are
either locked or tagged while equipment is cleaned or serviced.
3.
TMP4100, TMP4150, TMP4155: Ensure that appropriate pneumatic lock-out valves are installed.
2.3 ADJUSTMENT PROCEDURES
Periodically, you may need to make certain adjustments to keep your system operating at peak performance.
Procedures for adjusting the system air pressure, the pin stroke, and the marking depth of the impact pin are
located in the TMP4100 Operation Supplement or the TMP4150 Operation Supplement (supplied with the
marking system).
To Next Page
Loading...
