TMP4100-Series Installation/Maintenance
33480D01.DOC A-7
MATERIAL SAFETY DATA SHEET
STEEL PINS
1. PRODUCT DEFINITION
STEEL PINS DATE OF PREPARATION:
November 1, 1985
PRODUCT NAME:
A Supplemental Chemistry Sheet will be issued for each grade shipped to each customer. See Section 2.
2. HAZARDOUS INGREDIENTS
MATERIAL CAS NUMBER MATERIAL CAS NUMBER
Aluminum (Al) 7429-90-5 Manganese (Mn) 7439-96-5
Carbon (C) 7440-44-0 Molybdenum (Mo) 7439-98-7
Chromium (Cr) 7440-47-3 Nickel (Ni) 7440-02-0
Cobalt (Co) 7440-48-4 Selenium (Se) 7782-49-2
Columbium (Cb) 7440-03-1 Silicon (Si) 7440-21-3
Niobium (Nb-syn with Cb)
Titanium (Ti) 7440-32-6
Copper (Cu) 7440-50-8 Tungsten (W) 7440-33-7
Iron (Fe) 7439-89-6 Vanadium (V) 7440-62-2
No Threshold Limit Values (TLVs) exist for specialty steels. TLV may be applicable to constituent elements.
A Supplemental Chemistry Sheet will be sent covering each grade or type of steel purchased. It will have the maximum
level of each element that is present and required to be reported by OSHA Hazard Communication Standard 29 CFR
1910.1200.
See Appendix A for the Permissible Exposure Limits as determined by OSHA, ACGIH, and/or IDLH for each
component.
3. PHYSICAL DATA
Physical State: Solid pH: N/A
Boiling Point: 686-5660° C Specific Gravity: 1.8-19.3
Freezing Point: N/A Odor Threshold: N/A
Vapor Pressure: N/A Percent Volatile by Volume: N/A
Vapor Density: N/A Evaporation Rate: N/A
Water Solubility: Insoluble (except Manganese) Coefficient of Water/Oil Distribution: N/A
Appearance and Odor: Solid, Odorless Metal Melting Point: 2-17-3410° C
See Appendix A, Chemical and Physical Properties, for additional data (if any) for each element.
To Next Page
Loading...
