When updating delegate units, make sure they’re battery is charged >= 50% and that you
have the least amount of interference as interference will drastically increase the time to update.
After a delegate update, only the devices will be reboot.
5.14.2 Update delegate units
Once the WCAP update is started following screens will appear
The reset takes about 2 min
During the update the mic leds on the delegate units will light up red – left , green - right , after 10
sec, red – right , green - left , etc……
The update takes about 45 min
Remark : If a unit is accidentally switched off during the update (e;g; due to empty battery) , this will
temporarily stop the update , but after a few minutes the update for the other units will continue
To Next Page
Loading...
