Televic Confidea - Page 7

2
Trademarks
7
5.9.1 AUX In/out 26
5.9.2 General Aux settings - Audio routing 26
5.10 Regional settings 28
5.11 Security 28
5.12 Check firmware versions of delegate units 29
5.13 Check firmware versions of WCAP 30
5.14 Update 30
5.14.1 WCAP update 31
5.14.2 Update delegate units 33
6 Frequency selection 34
6.1 Check already used frequencies by other Confidea G3 systems 34
6.2 Selecting own frequencies 34
6.3 The current used frequency 35
6.4 Frequencies used by other Confidea G3 systems 35
6.5 Other indications 35
6.5.1 Signal quality 35
6.5.2 Sorting frequencies 35
7 Message screen 36
8 Guidelines on optimal WCAP setup and configuration 37
8.1 Positioning the Confidea Wireless Access Point 37
8.2 Optimizing the position the antennas 38
8.3 Max range of WCAP 39
9 Frequency Planning 39
9.1 Use with WiFi base stations nearby 39
9.2 Avoiding interference b.m.o. wifi collection points 40
10 Adding Cocon license to the WCAP 40
10.1 Introduction 40
10.2 Get the MAC address of your central equipment 40
10.3 Upload your license file 41
11 Appendix 42
11.1 Use of camera control feature 42
11.1.1 Overview 42
11.1.2 Connectivity 43
11.1.3 Commands for Confidea Gen III camera protocol 43