37
RIP
To activate RIP for the device, select the Enabled radio button for Global RIP Mode. To
configure an individual interface, select the desired RIP version and operation, followed by
placing a check in the 'Enabled' checkbox for the interface. Click the Save/Apply button to
save the configuration, and to start or stop RIP based on the Global RIP mode selected.
DNS
To access the DNS windows, click the DNS button in the Advanced Setup directory. The DNS
button appears when configuring WAN interface in PPPoA, PPPoE, MER or IPoA.
DNS Server
Select DNS Server Interface from available WAN interfaces OR enter static DNS server IP
addresses for the system. In ATM mode, if only single PVC with IPoA or static IPoE protocol is
configured, Static DNS server IP addresses must be entered.
DNS Server Interfaces can have multiple WAN interfaces served as system DNS servers but
only one will be used according to the priority with the first being the highest and the last one
the lowest priority if the WAN interface is connected. Priority order can be changed by
removing all and adding them back in again. Click the Apply / Save button when you are
finished.
To Next Page
Loading...
