Authentication Type: Open or Shared. Enter a WEP key that is either 5 or 13 ASCII characters or
10 or 26 Hex characters when your authentication type is Open and Shared.
Default Key: Specify a WEP key from the preset keys for current use. For example, if you select
Key 2, wireless clients must join your wireless network using this Key 2.
WEP Keys: ASCII and Hex are provided for you to configure. When you configure ASCII, you
can choose 5 or 13 ASCII codes (only “0~9, a~z, A~Z, @, *, -, _”can be allowed). When you
configure Hex, you can choose 10 or 26 hexadecimal numbers. One English letter or an Arabic
numeral takes up one ASCII code.
(2) WPA / WPA2 – PSK: A mode based on WPA / WPA2 - PSK.
You can enable personal (PSK) or mixed mode, but you must make sure that the wireless client
also supports the selected encryption method.
Encryption Type: Select AES, TKIP and TKIP & AES.
Key: Enter a security key that is either 8 - 63 ASCII characters or 8 - 64 Hex characters.
Key Update Interval: You can configure security key's update interval here within the range from
60 to 99999 seconds. If set to 0, the key will not be updated.
(3) WPA/WPA2: A mode based on Radius server authentication.
Radius Server IP: Display the Radius server's IP address.
Radius Port: Authentication port for Radius server. The default is 1812.
Encryption Type: Select AES, TKIP and TKIP&AES.
Key: Enter a key that is 1-64 ASCII characters.
Key Update Interval: You can configure security key's update interval here within the range from
60 to 99999 seconds. If set to 0, the key will not be updated.
Channel --- For an optimal wireless performance, you may select the channel with least
interference. It is advisable that you select 'Auto' to let the device detect and select the best
possible channel for your wireless network to operate on.
TX Power --- Define the maximum average transmitted output power (in dBm) of the device.
To specify the output power, use the slider to adjust the output power. Transmitted power
regulations differ in different countries.
Bandwidth --- Display the bandwidth of the radio channel. You can use this option to control
the bandwidth occupied by your link.
To Next Page
Loading...
