43
Step 8 Click Save, and wait until the device reboots to activate the settings.
----End
When LED1, LED2, and LED3 of the CPE are blinking, the device is connected to your ISP hotspot
successfully.
To access the internet with:
Wireless devices: Connect the wireless devices, such as a smart phone, to the WiFi network of
the wireless router which is connected to the CPE.
Wired devices: Connect the wired devices, such as a computer, to the LAN ports of the
wireless router which is connected to the CPE.
Parameters description
It specifies the working mode of this device.
WISP mode: In this mode, the device connects to an access point provided by ISP
in wireless manner.
It specifies the wireless network name (SSID) of the upstream AP.
It specifies the operating channel of the WiFi network to be bridged. It will be
automatically populated when you select an SSID to bridge.
It specifies the security mode of the WiFi network to be bridged. It will be
automatically populated when you select an SSID to bridge. If the WiFi network to
be bridged has a WiFi password, you need to enter the password manually.
DHCP (Dynamic IP): The device obtains an IP address and other parameters form
the DHCP server of upstream device for internet access.
Static IP Address: The device access the internet by setting the IP address,
subnet mask, default gateway and DNS server IP addresses manually.
PPPoE: The device access the internet using the PPPoE user name and password
provided by the ISP.
To Next Page
Loading...
Need help?
General
