Encoder to Decoder
Ad Hoc Network
In this example, the Cube Encoder (on the left) creates a wireless network, and
the Cube Decoder (on the right) joins that network. After joining the network,
the devices are paired and video streams from the Encoder to the Decoder.
WiFi range is limited in Ad Hoc mode, and Cube streams to a single device.
Infrastructure mode (through a router) is the preferable network configuration.
Ad Hoc mode is for operating in remote locations where a router is unavailable.
A screencast describing Encoder to Decoder Ad Hoc Networking is located at:
http://vimeo.com/18132088
A screencast describing networking basics is located at:
http://vimeo.com/14644326
10
To Next Page
Loading...
