Button Functions
Pairing Mode
Activating Pairing Mode
When Cube Encoders and Decoders are paired, it means that when they are
on the same network, the Decoder is configured to receive the streaming video
from the Encoder. Pairing is analogous to tuning your radio receiver into the
correct station. To pair, press and hold the Reset button on the Encoder
between 1-9 seconds (while not in Canon 5D mode) until the ENC and WiFI
LEDs blink green, then release. Within 30 seconds, press and hold the Reset
button on the Decoder until the DEC and WiFi LEDs blink green, then release.
The Encoder and Decoder are now paired.
Canon 5D HDMI Mode
The HDMI output on the Canon 5D switches from 1080i while in Live Preview
mode to 480p while in Record mode. Cube features a Canon 5D mode that
prepares the encoder for the resolution switch. To activate Canon 5D mode go
to System - Hardware IO - Button Mode and select Resolution Switch
(Canon 5D), then click Apply.
Activating Canon 5D Mode
•
1-4 secs: Canon 5D resolution switch
•
5-9 secs: Pairing
•
10-19 secs: Factory reset (save network)
•
20+ secs: Full factory reset
26
To Next Page
Loading...
