Using TeraCentral to View Video
Infrastructure Networking
1. Power-up your router.
2. Connect Cube (Encoder) to video, computer (via Ethernet), and power.
3. Launch TeraCentral from the included USB stick, or install TeraCentral on
your computer and launch it.
4. In TeraCentral, click the Configure Settings button for your Cube. Cube’s
menu system appears.
5. Open Cube’s Startup Wizard, click Next.
6. Click Configure Wireless Network, then Infrastructure Mode
7. Choose the desired network (i.e. your router), click OK.
8. Click Apply Network Settings then click Next. Cube has joined your
wireless network.
9. Confirm Video input then click Next.
10. Configure Streaming Video
•
Choose Wireless
•
Choose Software Decoder such as VLC (RTSP)
11. Click OK, then click Next and then complete the Wizard.
12. Physically disconnect Cube’s wired Ethernet connection.
13. Scan wireless networks, choose the same network that Cube just joined.
14. Close and relaunch TeraCentral. Your Cube will appear.
15. In TeraCentral, click Launch Video.
14
To Next Page
Loading...
