Network Your Cube Encoder &
Decoders Via Infrastructure
The following steps are also detailed in this screencast:
http://vimeo.com/18132179
1. Choose an existing network or create a new network using a wireless
router.
2. Configure your Cube Encoder for infrastructure networking.
•
Using your computer’s wireless networking, connect to your Cube
Encoder’s network.
•
Use Bonjour in your web browser to locate your Cube Encoder, access
the Web Interface, and logon.
•
Navigate to Network - Configuration.
•
In the Wireless Network Interface box, set Mode to Infrastructure,
then click Scan For Wireless Networks. Select the desired network,
then click Apply.
Note: Your ad hoc connection with Cube Encoder will terminate. This is
normal. Simply close this browser window and move to the next step.
3. Configure your Cube Decoder for infrastructure networking the same way
you configured your Encoder in step 2.
Your Cubes are now networked. The next step is to pair them.
29
To Next Page
Loading...
Need help?
General
