Reset to Factory Defaults
To restore Cube to factory defaults:
1. Click and hold the reset button for 20+ seconds.
2. LEDs 2 and 3 will alternately blink green, orange and red.
3. Release the button, Cube will reboot automatically.
Factory Configured Cube Pairs
If you bought your Cube Encoder and Decoder as a set, they were paired at
the factory to stream video in an ad hoc network configuration. Factory paired
Cube’s area easily identifiable as the encoder’s ad hoc network name will start
with “Cubelet” rather than “Cube”, and uses the Cubelet network for both the
encoder and decoder. To stream video, simply the plug the Cube Encoder into
your video source and your Cube Decoder into your monitor and power them
up. Video will begin streaming.
Factory Defaulting Cube Pairs
Factory default returns both units to an ad hoc network configuration and
maintains the pairing. To factory default your Cube Encoder or Decoder hold
down the reset button for approximately 8 seconds until the ENC and WiFi
lights begin color cycling. Note: After two seconds the lights will begin flashing
green. This is pairing mode. Continue to hold the buttons down until color
cycling begins to initiate the factory default, then release.
27
To Next Page
Loading...
Need help?
General
