Teradek CUBE Series - Create Ad Hoc Network; Encoder & Decoder Setup

Create Ad Hoc Network Between
Encoder & Decoder
The following steps are also detailed in this screencast:
http://vimeo.com/18132088
1. Configure your Cube Encoder for ad hoc networking (skip if Encoder is
already configured for ad hoc)
•
Power-up your Cube Encoder.
•
Using your computer’s wireless networking, connect to your Cube
Encoder on the infrastructure network where it resides.
•
Use Bonjour in your web browser to locate your Cube Encoder and
access the Web Interface and logon.
•
Using the Web Interface or the Start-up Wizard configure your Cube
Encoder for ad hoc networking.
2. Power-up your Cube Decoder.
3. Using your computer’s wireless networking, connect to your Cube
Decoder’s network.
4. Use Bonjour in your web browser to locate your Cube Decoder, access the
Web Interface, and logon.
5. Navigate to Network - Configuration.
6. In the Wireless Network Interface box, set Mode to Ad Hoc, then click
Scan For Wireless Networks. Select the network created by your
Encoder, then click Apply.
Your Cubes are now networked. The next step is to pair them.
28