Pairing Your Cube Encoder &
Decoder in the Menu System
1. Using your computer’s wireless networking, connect to the network where
your Cubes are located (either the infrastructure network you’ve created or
the ad hoc network created by your Cube Encoder.)
2. Use Bonjour in your web browser to locate your Cube Decoder, access the
Web Interface, and logon.
3. Navigate to Video Setup - Decoder Settings
4. In the Available Video Streams list, click and drag the desired video into
the box to the right, then click Apply.
Your Cubes are paired and the decoder is now outputting video.
These steps are detailed in both of the following videos:
•
Cube Encoder to Decoder Ad Hoc Networking, plus Pairing:
http://vimeo.com/18132088
•
Encoder to Decoder Infrastructure Networking, plus Pairing:
http://vimeo.com/18132179
31
To Next Page
Loading...
Need help?
General
