Model TA50RT
Rev. 1 04/99
SAFETY
2
2 - 3
SECURE all tools and other loose items to prevent injury to persons working on or below the work platform.
DO NOT use scaffolding, ladders or similar items to extend your reach while on the work platform.
DO NOT attempt to climb down the boom assembly, if the unit fails while the operator’s platform is raised or
extended.
Since the machine may be operated from its ground controls, precautions should be taken to prevent unauthorised
personnel from operating the work platform with the ground controls while the platform is in use.
The “UNPOWERED EMERGENCY MOVEMENT” procedure (described later in this manual) required
releasing the brakes and disconnecting the rear wheels, which results in there being no means to stop the unit’s
travel. Terex recommends using this procedure only in cases of emergency, and only for a short distance. Be
on guard against unit runaway on sloping surfaces. Movement speed shall not exceed 3 MPH (5 KPH).
DO NOT attempt to open any hydraulic line or component without first relieving system pressures and shutting
off fluid flow from the tank.
DO NOT allow anyone to tamper with, service or operate the machine from the ground control station while
personnel are on the platform, except in an emergency.
DO NOT alter, modify or disable any safety devices or interlocks.
DO NOT use the aerial work platform outdoors in electrical storms or in high wind situations. Maximum rated
wind speed is 12.5 m/s.
To Next Page
Loading...
