Model TA50RT
Rev. 1 04/99
5
5 - 9
MAINTENANCE SCHEDULES
5.3. SERVICING
Servicing to be carried out by a trained technician only.
5.3.1 DAILY ROUTINE SERVICING
5.3.1.1. Hydraulic Oil Level
Before checking the oil level, ensure that the machine booms are stowed in the travelling position and the
machine is standing on level ground. The oil level must be 1" (2.54 cm) below the top of the oil level gauge.
Refer to the lubrication chart for the correct grade of oil if the reservoir requires topping up.
After checking the oil level, ensure the oil filler plate is fully secure to prevent water contamination or contami-
nation by other impurities .
5.3.1.2 Tyre Condition
Check the condition of all four tyres.
5.3.2. WEEKLY ROUTINE SERVICING
5.3.2.1. Hydraulic System
Inspect the hydraulic system as follows:-
(a) Pressurise the hydraulic circuit and inspect the system for any signs ofoil leakage, particularly at
flexible hoses, connections and hydraulic components.
(b) Examine all pivot pins on booms, cylinders and the levelling system to ensure that they are positively
secured in position.
5.3.2.2. Steering
Check the steering cylinder for oil leakage and the linkage for signs of water.
To Next Page
Loading...
