3
OPERATING PROCEDURES
Model TA50RT
Rev. 1 04/99
3 - 3
3.4. UNLOADING PROCEDURES
TO AVOID SERIOUS PERSONAL INJURY OR DEATH, ENSURE THAT THE MACHINE IS
IN “CREEP “ DRIVE SPEED WHILE UNLOADING FROM A TRUCK OR TRAILER.
Inspect the outside of the unit for damage (including the underside). Inspect all hoses, boom sections and
cables for chafing or road damage. Confirm that all swing bearing bolts are tight (refer to specifications).
Unlock and open hydraulic compartment. Inspect all electrical and hydraulic connections for damage and
security.
Check fluid level on the hydraulic tank, and add fluid as required (see lubrication chart).
Close hydraulic cover.
Attach the unit to a winch for the unloading procedure.
ALWAYS ATTACH THE UNIT TO A WINCH WHEN LOADING OR UNLOADING FROM A
TRUCK OR TRAILER. CONNECT WINCH TO THE TIE DOWN LUGS ON THE UNDER-
CARRIAGE. UNASSISTED LOADING OR UNLOADING OF ANY MOBILE PLATFORM IS
NOT RECOMMENDED.
READ AND UNDERSTAND ALL SAFETY, CONTROL AND OPERATING INFORMATION
FOUND ON THE MACHINE AND IN THIS MANUAL BEFORE OPERATING THE UNIT.
To Next Page
Loading...
