Model TA50RT
Rev. 1 04/99
5
5 - 23
MAINTENANCE SCHEDULES
5.4.2.2. Slew Gear Lubrication
The teeth must be thoroughly cleaned, particularly within the gaps between the teeth, before lubrication. For
this operation we recommend a proprietary solvent.
Use a suitable caulking gun to apply a 6 mm diameter bead of grease around the full circumference of the gear.
Brush the grease into the gear surfaces.
Lubrication Frequency- Slew Gear
- Approximately 50 hours.
Grease Characteristics - Slew Gear
The grease used on the slew gears must comply with the following characteristics:
- Extreme pressure grease.
- Water and temperature resistant.
- Temperature range .............25° F to 400° F (-4°C to 200° C)
Terex Aerials Limited recommend the following grease for the slew gear.
- KEYSTONE MOLY 25 OPEN GEAR COMPOUND (S.A.Part No. 10126400)
It is possible to use other brands of grease provided that they offer greasing characteristics similar to the type
listed above.
To Previous Page
Loading...
