OPERATING PROCEDURES
3
Model TA50RT
Rev. 1 04/99
3 - 4
Remove all machines tie downs. Remove wheel chocks, if used. Turn the engine on using keyswitch and set the
Ground\Cage (platform) selector switch to “CAGE”.
Enter the platform. Test all platform functions.
Raise the boom so that the platform will clear any obstacles as the machine is driven down the loading ramp.
Carefully drive the unit off the truck or trailer with the assistance of a winch.
Note: The brakes are automatically released for driving, and will automatically apply when the unit stops.
Before placing the unit into service, all operators must read and understand the contents of the Operator’s
Manual.
Upon initial unloading of the machine the PDI (Pre-Delivery Inspection Form) must be completed and returned
in order to activate the Terex Limited Warranty.
To Next Page
Loading...
