Tesmec PT2450 - Page 22

HYDRAULIC PULLER TENSIONER PT2450
Manual: MI-PT2450-050-00-GB Date: 28.07.2018 Author: AT Page: 19 of 89
The radio control display is equipped with 4 control pages of the main parameters of the machine, and the
operator cannot remain near the machine during the stringing operation.
 Led 1: ROPE CLAMP CIRCUITE 1 CLOSED
 Led 2: NEGATIVE BRAKE BULL-WHEEL CIRCUITE 1 OPEN
 Led 3: NEGATIVE BRAKE REEL ELEVATOR CIRCUITE 1 OPEN
 Led 4: OPERATING MODE PULLER TENSIONER, REVERSE FROM THAT SET CIRCUITE 1
 Led 5: ROPE CLAMP CIRCUITE 2 CLOSE
 Led 6: NEGATIVE BRAKE BULL-WHEEL CIRCUITE 2 OPEN
 Led 7: NEGATIVE BRAKE REEL ELEVATOR CIRCUITE 2 OPEN
 Led 8: OPERATING MODE PULLER TENSIONER, REVERSE FROM THAT SET CIRCUITE 2
 Led 9: NO ATTIVE
 Led 10: OIL TOO HOT
 Led 11: BULL-WHEEL SELECTION+REEL ELEVATOR DISABLED CIRCUITE 1
 Led 12: BULL-WHEEL SELECTION+REEL ELEVATOR DISABLED CIRCUITE 2
 Led 13: ELETTRONIC CONNECTION ATTIVE
 Led 14: SYNCHRONIZER DEVICE ATTIVE
 Led 15: MECCANICAL CONNECTION ATTIVE
 Led 16: ELETTRONIC CONNECTION WITH ANOTHER MACHINE ATTIVE
Led indication
Battey
Push button menù
pages.
Working parameter
machine
Alarm Machine
Battery status
Radio status
connection
Led indication machine
parameters