HYDRAULIC PULLER TENSIONER PT2450
Manual: MI-PT2450-050-00-GB Date: 28.07.2018 Author: AT Page: 68 of 89
6.1.1 MACHINES SET-UP
Before use, the machines must be set up to be used in connection by assigning the correct identification
numbers.
When machines are connected, the machine with the highest reference number is the MASTER
machine, while the lower number machines are all SLAVE machines.
Through the MASTER machine it is possible to move and control all other machines.
The setting of the single machine is carried out on the relevant control panel in the "Machine settings" menu
in the "Machine work configuration" sub-menu , by default the "machine 1" number is
highlighted
1
2
4
3
To Next Page
Loading...
