HYDRAULIC PULLER TENSIONER PT2450
Manual: MI-PT2450-050-00-GB Date: 28.07.2018 Author: AT Page: 3 of 89
2. INTRODUCTION
2.1 MANUFACTURER
Via Zanica, 17/O
24050 - GRASSOBBIO
BG - ITALY
tel. (+39)-035-4232911
fax (+39)-035-4522445
e-mail: service-stringing@tesmec.com
parts-stringing@tesmec.com
info@tesmec.com
Via Pertegalli, 2
24060 - ENDINE GAIANO
BG - ITALY
tel. (+39)-035-825024
fax (+39)-035-826375
e-mail: service-stringing@tesmec.com
parts-stringing@tesmec.com
info@tesmec.com
2.2 COMMUNICATIONS WITH THE MANUFACTURER
For any information related to the machine (use, maintenance, spare parts) always state Model, Serial
Number, Manufacturing Year and Order.
These data can be found in the machine-identifying table.
2.3 PURPOSE OF THE MANUAL
This instruction manual and all publications attached are an integral part of the machine and provides
guidance for conducting, conducting, operation and maintenance.
Reading the instruction manual is essential and necessary for the training and information of staff likely to
operate on the stretching machine; given the specific use of the instructions were produced for
professionals, thereby taking into account the level of general education and acumen that can reasonably
be expected from such operators.
Although the book provides information to operate correctly and also shows the residual risks of the
operations, this document does not replace the experience of the " experienced " , believed formed and
informed their duties and knowledge of operational procedures and safety related to them.
For their own safety and the safety of persons exposed to the risks present during the lifecycle of the vehicle
and its equipment, it is compulsory to refer to the instructions and always contact the distributor
Tesmec S.p.A. in the case of any doubt arising from the lack or difficult interpretation of the instructions
themselves.
Read and understand this manual carefully in all its parts before starting operation.
Do not do anything which is difficult to interpret the instructions, should always contact the distributor
Tesmec S.p.A.
Do not do that no information has been provided by the distributor.
Do not do anything differently than described in this manual.
Do not perform operation expressly prohibited in this manual.
If you experience operating conditions not covered or not described in the instruction manual, contact your
distributor immediately Tesmec S.p.A.
The distributor Tesmec S.p.A.
disclaims any liability related to non-compliance of the instructions in this
manual.
To Next Page
Loading...
