Tesmec PT2450 - Command “Connected Machine”

HYDRAULIC PULLER TENSIONER PT2450
Manual: MI-PT2450-050-00-GB Date: 28.07.2018 Author: AT Page: 73 of 89
6.1.2 COMMAND “CONNECTED MACHINE”
In the following pages there are the possible commands that can be made with the machines in electronic
connection:
When using connected machines, the following controls effect on all machines when operated from the
MASTER machine:
• Speed control (with relative Joystick);
• Pull-adjusting control (with relative potentiometer);
• Rope-clamp selector (with relative switch);
• Active / de-active electronic synchronize (with relative switch) - (see Cap.6.1.3).
While the following commands / settings must be performed on each individual SLAVE machine:
• Reel-winder working pressure (with relative potentiometer);
• Reset of meter counter (with relative button on control panel - see cap. 5.5.1);
• Positioning the rear and back plug (with relative button on control panel - see cap. 5.5.2.2.);
Joystick
speed control
Rope
clamp
Pull force
value
synchronize
switch
Reel winder pressure
control