HYDRAULIC PULLER TENSIONER PT2450
Manual: MI-PT2450-050-00-GB Date: 28.07.2018 Author: AT Page: 67 of 89
6. AVAILABLE DEVICES
The machine can be equipped with the following additional device:
6.1 MACHINE ELECTRONIC CONNECTION (ALL.089)
This device allows a single operator to control multiple "twin" machines (up to a maximum of 4 machines)
simultaneously, synchronizing the stringing operations (as regards the main operating parameters).
Each machine must be equipped with this device with the possibility of working in different work
configurations depending on the number of connected machines.
The machines must be connected through a special connecting cable; the un-used plugs on the first and
on the last machine (right and left) must always be closed with the related caps.
To grant the continuous connection of the machines, a special protection device must be provided for the
connection cables, to avoid accidental disconnection of the communication between the machines.
WARNING
Connect the connection cables before switching on and using connected
machines. The cables must be connected when the machine have DIESEL OFF.
WARNING
If the operator disconnect the machine connection cables, during operation, you
will have the immediate emergency stop of all connected machines.
WARNING
Before using the machines connected to each other, make sure that the fine
braking gear configuration is HIGH-PULL in each machine.
To Next Page
Loading...
