9 Performing the measurement
57
Start measurement: tap .
Zeroing takes place.
Readings are displayed.
If the Draught measurement parameter is enabled in the reading
display, a draught measurement is automatically started in parallel to
the flue gas measurement. In the List measurement data view, the
parallel draught measurement can be stopped/restarted. This draught
measurement is performed separately to a measurement of the
Draught measurement type.
For the draught measurement, the minus connection for differential
pressure measurement must be free (ambient pressure, not closed).
Tap on the draught reading display or next to it.
End measurement: tap .
Automatic display after connection of one or more Smart Probe testo 115i
or testo 915i during flue gas measurement
If several temperature probes are connected in total (external probes and/or
testo 115i or testo 915i), the temperature probes are used for flue gas
measurement according to the following procedure.
The AT probe = external cable probe always has first priority.
To Next Page
Loading...
