Testomat EVO TH CAL - Content; Table of Contents

Content
2
Content
Content ................................................................................................. 2
Important safety information ............................................................. 5
Intended use .................................................................................... 5
Qualification of personnel ................................................................ 5
Warnings in this manual .................................................................. 6
Additional documentation ................................................................ 6
Special attention is required at this point .............................................. 6
General Information ......................................................................... 6
Requirements for the installation site............................................... 6
Requirements of cable for mains voltage and system components
and installed lines ............................................................................ 7
Requirements for cable ducts .......................................................... 7
During assembly .............................................................................. 8
During operation .............................................................................. 8
During cleaning ................................................................................ 9
Malfunctions/repairing a defective device ........................................ 9
During disposal ................................................................................ 9
Operating requirements ................................................................. 10
Delivery includes: ............................................................................. 11
Service description ........................................................................... 11
Available indicators for Testomat
®
EVO TH CAL devices .................. 12
Assembly ........................................................................................... 13
Assembling the Testomat
®
EVO TH CAL ........................................... 13
Use of the Testomat
®
EVO TH CAL within a pressure range of 0.3 to
1 bar .................................................................................................... 13
Connecting the water intake and discharge ........................................ 14
Water intake ................................................................................... 14
Water drain .................................................................................... 15
Connect mains and devices ................................................................ 15
Block diagram of Testomat
®
EVO TH CAL .................................... 16
Internal structure of Testomat
®
EVO TH CAL ..................................... 17
Cable ducting ................................................................................. 18
Install power supply board and connect mains voltage ................. 18
Connect system components ........................................................ 19
Connect inputs and outputs ........................................................... 21
RS232 interface terminal assignment ............................................ 22
Connect indicator bottle ................................................................... 23
Insert indicator bottle ..................................................................... 23
Open water intake .......................................................................... 23
Device settings and data input ....................................................... 24
Functions of the control and display elements ............................. 24
Switching the Testomat
®
EVO TH CAL device on/off .................... 24
Display functions ............................................................................ 25
Control and function keys .............................................................. 26
Operating system ........................................................................... 27
Control elements on the control board........................................... 30
Mounting the SD card .................................................................... 30
Status displays of the SD card ....................................................... 30