Input basic programming data
44
Water shortage
The water shortage error is a special case, since one further setting
can be configured for this error. In the menu, under
=> Basic program => Waterlow count
the number of consecutively occurring errors before the alarm is trig-
gered can be set. An error is then generated for each measurement
cycle.
Number of water shortage errors
This function is specially provided for systems subject to intermittent
low water pressure errors, which trigger a "Water low" error in the
device. The number 0 can be set for an immediate message, or the
setting can be raised to 250 occurrences before the error alert is
sent.
Error history
Select => Service => Error History
to call up error history.
Select "Show(OK)", to show the list of error messages.
Confirm the input with "OK"
Select an error message from the list using the arrow keys.
The time and date of the occurrence are shown.
Again, press "OK".
Now – depending on the error type – the start and end of the error
are shown.
If the error remains current, no end time is registered.
To delete the entire list, select
Delete(OK) 20
The number indicates the number of stored notifications.
The error history has room for up to 20 notifications.
To Next Page
Loading...
