Lab C: Assembly Programming
Build and Load
5. Click the “Rebuild All” button and watch the tools run in the build window. Debug
as necessary. To open up more space, close any open files or windows that you do not
need.
6. If the “Load program after build” option was not selected in Code Composer
Studio, load the output file onto the target. Click: File Load Program…
If you wish, right click on the source window and select Mixed Mode to debug using
both source and assembly.
7. Single-step your routine. While single-stepping, open memory windows to see the values
located in table [9] and data [9] . Open the CPU Registers. Check to see if the program is
working as expected. Debug and modify, if needed.
Optional Exercise
After completing the above, edit LabC.asm and modify it to perform the initialization
process using a RTP/PREAD rather than a load/store/BANZ.
End of Exercise
C28x - Appendix C - Assembly Programming C - 21
To Next Page
Loading...
Need help?
General
