Texecom Premier 8XP-W - Learning Premier Smartkey

Premier 8XP-W & 32XP-W Installation Manual
21
Learning Premier SmartKey™
All Premier SmartKey™ must be assigned to one of the available users on the system. The users
available will vary depending on the control panel:
Control Panel Available Users
Premier 412 Users 1 to 31
Premier 816 Users 1 to 31
Premier 832 Users 1 to 63
Premier SmartKey™ are assigned to users as follows:
1. Select engineer’s mode by entering the engineer code followed by / then .
2. Enter  to select the Program Users menu.
3. Enter the two digit user number that you want to assign the Premier SmartKey™ to e.g.,
.
4. Press the / key, if an error tone is generated then the receiver is not installed or
configured correctly (see Receiver Installation above).
5. Press the power button on the Premier SmartKey™, the panel will generate an
acceptance tone and the Premier SmartKey™ is now assigned to the selected user.
6. If required, a user access code can also be assigned to user in the normal way.
 
   
  
  

Ent er User
Number 
  
  
Ent er Engineers code
Then press t hen
/

 
Acceptance Tone
from Panel

/
