Texecom Premier 8XP-W - Removing Premier Smartkey

Premier 8XP-W & 32XP-W Installation Manual
18
Removing Premier SmartKey™
If a Premier SmartKey™ is no longer required it must be unassigned from the system. To remove a
Premier SmartKey™ from a user, proceed as follows:
1. Select engineer’s mode by entering the engineer code followed by / then .
2. Enter  to select the Program Users menu.
3. Enter the two digit user number that you want to remove the Premier SmartKey™ from e.g.,
.
4. Press the / key, the panel will generate an acceptance tone and the Premier
SmartKey™ is no longer assigned to the selected user. Note: If the Premier SmartKey™ was
assigned to user 02 onwards the user access code is also deleted.
 
   
  
  

Enter User
Number

  
  
Enter Engineers code
Then press then
/

 
Acceptance Tone
from Panel

/
