Premier 8XP-W & 32XP-W Installation Manual
6
4. System Design Considerations
To ensure correct setup and operation of the Wireless Network it is important that the following
procedures are used when learning and placing devices.
Learning Devices
All devices should be learnt before they are placed in their final location. The expander should be
in commission mode, please see page 32.This will ensure that they are registered on the receiver
or control panel, and that Mesh Networks and routing are established correctly. Please refer to the
relevant section in this document to Learn Devices to the system.
Devices should be at least 30cm’s away from the receiver when being learned.
Placing Devices
Once all of the devices have been learnt, they will need placing in their desired location, this
should be done by installing devices closest to the expander first and then working outwards so
that the last devices installed are those furthest away from the expander.
Make sure to install devices with the expander in Commission mode. See page 32.
Devices also have a commission mode which will indicate a secure and valid path of
communication to the receiver. See page 32.
You should wait at least 15 minutes after installing the last device to make sure routing has
been correctly established between all system devices.
For maximum reliability and system integrity avoid long and thin set-ups.
Devices are capable of hopping through up to two other devices, or a maximum of three
hops.
To Next Page
Loading...
