EasyManua.ls Logo

Texecom Premier 8XP-W - Walktest Mode

Texecom Premier 8XP-W
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Premier 8XP-W & 32XP-W Installation Manual
29
Walktest Mode
Used to initiate & stop Walktest Mode
If the Walktest broadcast message fails the following will be seen
In this case the system has not had time to synchronise properly, if you are in Commission Mode
page 32 you should wait 4 minutes and try again. If not in commission mode you should wait 15
minutes and try again.
 
 
 
   
 
   
When u pdating devic es a mes s age is
sent to all to ena bl e the LE D s & re duce
the co mmu nicatio n time to 10 se cs
b etwee n activa ti on s . P ol lin g time i s n ot
affected .
 
  
 
   
/
/
/
 
 
 
   
/
 
   
 
   
/
/

Table of Contents

Related product manuals