Premier 8XP-W & 32XP-W Installation Manual
11
6. Programming
It is highly recommended that you upgrade the Panel Firmware to the latest version to ensure full
compatibility; however the system is backwards compatible as detailed in the table on page 4.
When using the Premier 8XP-W it is only possible to learn devices to slots 1-8 on the expander.
Slots 9-32 will still be shown in Ricochet Monitor, and on the keypad, however no devices can
be learned to them.
Premier 24 V8.24, Premier 48/88 & 168 V8.15 Firmware & later
Option Switch Settings
For this version of firmware option switches 1,2 & 4 should be OFF.
Configuring Radio devices
Up to 32 wireless devices of any combination can be learnt on to the system. The number of
Premier SmartKey™ is limited to the maximum number of users (i.e. 24 0n the Premier 48).
On the Premier 8XP-W the maximum number of devices including Premier Smartkey™ is 8.
Wireless devices can then be mapped on to the system along with conventional detectors.
The top line on the display shows the serial number of the device and also the status i.e. Active,
Tamper etc.
The bottom line of the display shows the signal strength and also which zone/user the device is
mapped to.
Signal strength should be greater than 30.
Signal strength is only displayed when in commission mode. When not in commission mode
the keypad will display 255.
The signal range is between 0 and 99
In the case of devices that are hopping the display on the panel keypad shows the average of
the hopped signal strengths.
Follow the instructions on the next page to learn devices to the system, once complete follow the
instructions in the relevant control panel manual to programme zone type, attributes and user
permissions. Place devices in their final location ONLY after they have been learned to the system.
To Next Page
Loading...
