Texecom Premier 8XP-W - Selecting Expander Address

Premier 8XP-W & 32XP-W Installation Manual
10
The networks are made up of four terminals incorporating power and data. To ensure correct
operation, all four terminals on the device must be connected to the corresponding terminals on the
control panel or previous device.
Expanders can be connected using 4-core cable. However, it is recommended that 6 or 8-core cable
is used as the spare cores can be used to ‘Double Up’ on the power connections if needed.
 Standard 7/0.2 alarm cable can be used for most installations. However, under certain
conditions it may be necessary to use screened cable.
Selecting an Address
Each expander must be assigned a different address using the DIL switches located on the PCB.
The table below shows the expander addressing:
Address DIL 1 DIL 2 DIL 3 DIL 4
1 On or Off Off Off Off
2
4
3
1
2 Off On Off Off
2
4
3
1
3 Off Off On Off
2
4
3
1
4 Off Off Off On
2
4
3
1
5 On Off Off On
2
4
3
1
6 Off On Off On
2
4
3
1
7 Off Off On On
2
4
3
1
8 On Off On On
2
4
3
1
 Never set two expanders on the same network to the same address. Expanders are factory set
to address 1.On legacy panels the expander will occupy 1 x Expander slot on the control
panel, as well as the Network Receiver slot.